loading loading
Search this catalogue
 [?]
 [?]
 [?]
 [?]

Catalogue Entry

enlarge
Photo: Boston Imaging Digital Solutions; © Cape Ann Museum
inv. 139
Three Master at Sea
1850s
Graphite on paper
6 x 8 3/4 in. (15.2 x 22.2 cm)
No inscription found
Commentary

This depiction of a full-rigged ship under reefed topsails is one of a very few finished pencil drawings from Lane’s hand which have survived. Its feeling of depth has been enhanced by thin washes of ink or watercolor on the sails, hull, and water. The delineation of the waves aside, this rendering has nearly a photographic quality. This speaks to more than Lane’s mastery of hull form and rigging; it proclaims his understanding of light and shadow to give depth and mass to an image of a ship in motion.

The depicted vessel is a large ocean carrier—not a clipper, but of a more burdensome hull type later called a “down-easter” after the coastal Maine region where it was perfected in the post-Civil War decades. On a broad reach in heavy seas, she is under shortened sail but making good headway.

Her flying jib and outer jib are furled, as are her topgallant sails and the main course. Her topsails are single-reefed with the reef tackles rigged for the bottom reefs, if needed to shorten sail further. Her spanker is set without reefing to balance the sail plan and make steering easier. Her fore course is fully set, but her fore, main, and mizzen royals together with their yards have been lowered and stowed to reduce windage aloft (see keyed drawing). Lane the artist and sailmaker’s son combined his training and heritage to create a near perfect image of nautical artistry and good seamanship.

– Erik Ronnberg

Supplementary Images
Three Master at Sea, 1850s (inv. 139). Key identifying sail types
Key identifying sail types
Photo: © Erik Ronnberg
Three Master at Sea, 1850s (inv. 139)
Photo: Marcia Steele; © Cape Ann Museum
Three Master at Sea, 1850s (inv. 139)
Photo: Marcia Steele; © Cape Ann Museum
Three Master at Sea, 1850s (inv. 139)
Photo: Marcia Steele; © Cape Ann Museum
Explore Catalogue Entries by Keywords view all keywords »

Historical Materials

Below is historical information related to the Lane work above. To see complete information on a subject on the Historical Materials page, click on the subject name (in bold and underlined).
[ top]

The term "ship," as used by nineteenth-century merchants and seamen, referred to a large three-masted sailing vessel which was square-rigged on all three masts. (1) In that same period, sailing warships of the largest classes were also called ships, or more formally, ships of the line, their size qualifying them to engage the enemy in a line of battle. (2) In the second half of the nineteenth century, as sailing vessels were replaced by engine-powered vessels, the term ship was applied to any large vessel, regardless of propulsion or use. (3)

Ships were often further defined by their specialized uses or modifications, clipper ships and packet ships being the most noted examples. Built for speed, clipper ships were employed in carrying high-value or perishable goods over long distances. (4) Lane painted formal portraits of clipper ships for their owners, as well as generic examples for his port paintings. (5)

Packet ships were designed for carrying capacity which required some sacrifice in speed while still being able to make scheduled passages within a reasonable time frame between regular destinations. In the packet trade with European ports, mail, passengers, and bulk cargos such as cotton, textiles, and farm produce made the eastward passages. Mail, passengers (usually in much larger numbers), and finished wares were the usual cargos for return trips. (6) Lane depicted these vessels in portraits for their owners, and in his port scenes of Boston and New York Harbors.

Ships in specific trades were often identified by their cargos: salt ships which brought salt to Gloucester for curing dried fish; tea clippers in the China Trade; coffee ships in the West Indies and South American trades, and  cotton ships bringing cotton to mills in New England or to European ports.  Some trades were identified by the special destination of a ship’s regular voyages; hence Gloucester vessels in the trade with Surinam were identified as Surinam ships (or barks, or brigs, depending on their rigs). In Lane’s Gloucester Harbor scenes, there are likely (though not identifiable) examples of Surinam ships, but only the ship "California" in his depiction of the Burnham marine railway in Gloucester (see Three Master on the Gloucester Railways, 1857 (inv. 29)) is so identified. (7)

– Erik Ronnberg

References:

1. R[ichard)] H[enry] Dana, Jr., The Seaman’s Friend, 13th ed. (Boston: Thomas Groom & Co., 1873), p. 121 and Plate IV with captions.

2. A Naval Encyclopaedia (Philadelphia: L. R. Hamersly & Co., 1884), 739, 741.

3.  M.H. Parry, et al., Aak to Zumbra: A Dictionary of the World’s Watercraft (Newport News, VA: The Mariners’ Museum, 2000), 536.

4. Howard I. Chapelle, The History of American Sailing Ships (New York: W.W. Norton & Co., 1935), 281–87.

5. Ibid.

6. Howard I. Chapelle, The National Watercraft Collection (Washington, DC: Smithsonian Institution, 1960), 26–30.

7. Alfred Mansfield Brooks, Gloucester Recollected: A Familiar History (Gloucester, MA: Peter Smith, 1974), 67–69.

Golden State
1884
Photograph
From American Clipper Ships 1833–1858, by Octavius T. Howe and Frederick C. Matthews, vol. 1 (Salem, MA: Marine Research Society, 1926).

Photo caption reads: "'Golden State' 1363 tons, built at New York, in 1852. From a photograph showing her in dock at Quebec in 1884."

[+]
photo (current)
"Friendship of Salem"
Built in 1998

A replica of an early nineteenth-century full-rigged ship.

[+]
artwork
Homeward Bound
c.1865
Hand-colored lithograph
Published by N. Currier, New York
Library of Congress (2002695891)
[+]
illustration
Ship
1885
Engraving from Merchant Vessels of the United States (Washington, DC: Government Printing Office)

Engraving of ship.

[+]
artwork
Packet "Nonantum" Riding out a Gale
Samuel Walters
1842
Oil on canvas
24 x 35 in.
Peabody Essex Museum, Salem, Mass.

Walters' painting depicts the "Nonantum" homeward bound for Boston from Liverpool in 1842. The paddle-steamer is one of the four Clyde-built Britannia-class vessels, of which one is visible crossing in the opposite direction.

Image: Peabody Essex Museum
[+]
illustration
Ship
Engraving in R. H. Dana, The Seaman's Friend, 13th ed. (Thomas Groom & Co. Publisher, 1873)

A ship is square-rigged throughout; that is, she has tops, and carries square sails on all three of her masts.

[+]
artwork
Silhouettes of vessel types
Charles G. Davis
Book illustrations from "Shipping and Craft in Silhouette" by Charles G. Davis, Salem, Mass. Marine Research Society, 1929. Selected images
[+]
Provenance (Information known to date; research ongoing.)
Cape Ann Museum, Gloucester, Mass.
Exhibition History
No known exhibitions.
Published References
No known published references.
Related Historical Materials

Vessel Types

Record last updated February 7, 2017. Please note that the information on this and all pages is periodically reviewed and subject to change.
Citation: "Three Master at Sea, 1850s (inv. 139)." In Fitz Henry Lane Online. Gloucester, MA: Cape Ann Museum. www.fitzhenrylaneonline.org/catalogue/entry.php?id=139 (accessed on August 24, 2025).